- RGB Critter BTThe app-controlled flashlight.
- Flow Art KitsSwap heads. Keep the light.
- Light Painting ToolsSwap mods. Shape the light.
- Flow Art AccessoriesGrab spares. Keep it spinning.
Silicone Saber Cap and Cap Mount
How the Silicone Saber Cap and Cap Mount go on.
Step by step for the Silicone Saber Cap, the Silicone Cap Mount, the Counterweight System and the Counterweight Kit.
Silicone Saber Cap
Designed for both your saber tube and the Silicone Cap Mount. No tools.
-
1
Fits a saber tube or Cap Mount
All AOAM sabers, old and new. A Cap Mount connects to the back end of your saber.
-
2
On a tube, take the Twist-On Cap off
Recommended, but not necessary.
-
3
Push the Silicone Cap straight on
Pull straight off to remove.
Mount, Counterweight System and Kit
The Cap Mount connects to the back end of your saber. The numbers on the picture match the steps.
-
1
Start with your Handle Extension
On an RGB Critter BT, skip steps 2 and 4 (see below).
-
2
Drop the shim into the handle
Line it up with the hole.
-
3
Twist the mount on, over the shim
Keep twisting until it is fully tight.
-
4
Insert the screw (recommended)
Through the shim into the handle. Tighten with the 4 mm Allen key.
-
5
Slide in the weight
All the way into the mount. With the Mount alone, the Contact Saber Weight is optional and sold separately.
-
6
Tighten both set screws
Already in the mount. Use the 2 mm Allen key to lock the weight in.
-
7
Push on the Silicone Saber Cap
Included in the Kit, sold separately with the Mount and System. Pull straight off to remove.
Tools: a 2 mm Allen key for the set screws and a 4 mm Allen key for the connecting screw.
Set up and spinning?
Leave a review for the one you got. It helps other spinners pick the right setup.
On an RGB Critter BT
Twist the mount straight on
Twist it onto the rear threads of the Critter BT until it is fully tight, then slide in the weight, tighten the set screws and push on the cap.
No shim, no screw
The shim and connecting screw are only for the Saber Handle Extension.