Saber Twist-On Cap
Caps the tube and reflects light back down the blade.
Caps the tube and reflects light back down the blade.
WRITE REVIEW
The Saber Twist-On Cap closes off the end of a saber tube and adds a built-in reflector that bounces the RGB Critter's light back down the tube for a brighter, fuller blade.
One already comes in the box with every flow arts saber tube, at no extra cost: White with the Sol Saber Tube, Clear with the Honeycomb, Butterfly and Stellar tubes, and one per tube in the Saber Kit, LED Staff Kit and both Contact Saber Kits. Buy this listing for a spare, a replacement, or the other color.
Full details and specs Show less
Features
- Built-in reflector for a brighter, more even blade
- Threaded hard plastic, hand-tighten, no tools
Where it fits
Current saber tubes: yes, directly. Our current saber tubes (Sol, Butterfly, Honeycomb, Stellar) have the thread built into the polycarbonate tube itself, with no aluminum fittings. This cap threads right on.
Older saber tubes with aluminum fittings: no. If your saber tube has an aluminum fitting attached to the end of the tube, this cap is not compatible with it. It only fits the current, all-plastic threaded tubes.
Light painting tubes: the 36 inch only. The 36 inch light painting tube is threaded at its free end, and one of these caps already comes in the box with it. The 5 to 29 inch lengths have no threads anywhere, and no adapter changes that: this cap mates only with a tube that has the thread built into the polycarbonate.
It is never a choice between this cap and a Flow Cap. Thread this one into the tube tip, then push a Flow Cap on over the top of it if you want the silicone bumper as well. Run either on its own, or both together.
