Flow Cap
WRITE REVIEW
It fits every saber we have ever made. The Flow Cap is a friction fit over the 1 inch end of the tube, not a threaded part, so it does not depend on any particular thread, clip, or hardware. Sol, Stellar, Butterfly, Honeycomb, the discontinued Hive, every saber kit and saber accessory we have ever shipped going back to 2012, our light painting tubes, and the current modular saber system all take the same cap. If you bought a tube from us at any point, this is the cap for it.
Full details and specs Show less
The Flow Cap is a soft, ultra-durable silicone end cap for saber tubes and flow staffs. It pushes on and pulls off, no clips, holes, or hardware. Made from premium, non-toxic silicone, it protects your tube ends from drops and impact while adding clean balance and control for performance flow.
Available in Matte Black and Transparent.
Features
- Fits every AOAM saber tube, current or older generation
- Secure press-on fit, no hardware needed
- Extremely durable and impact-resistant
- Adds 35g of counterweight for smoother swings
- Pushes on and pulls off. It never twists or threads on.
Where it fits
- The open end of a saber or light painting tube, current or older generation
- The rear of the Flow Cap Mount, which is how a Flow Cap mounts to the back of a hilt. Sold separately, and also included in the Flow Cap Counterweight System.
Those are the only two seats. If you also run the Saber Twist-On Cap, thread the Twist-On Cap on first and push the Flow Cap on over the top of it.
