Saber Twist-On Cap
WRITE REVIEW
The Saber Twist-On Cap closes off the end of a saber tube and adds a built-in reflector that bounces the RGB Critter's light back down the tube for a brighter, fuller blade.
It threads on and hand-tightens. No tools.
Features
- Built-in reflector for a brighter, more even blade
- Threaded hard plastic, hand-tighten, no tools
- Stacks under a Flow Cap, so you can run both at once
- Or run it alone for a traditional closed-end saber
Full details and specs Show less
Where it fits
Current saber tubes: yes, directly. Our current saber tubes (Sol, Butterfly, Honeycomb, Stellar) have the thread built into the polycarbonate tube itself, with no aluminum fittings. This cap threads right on.
Older saber tubes with aluminum fittings: no. If your saber tube has an aluminum fitting attached to the end of the tube, this cap is not compatible with it. It only fits the current, all-plastic threaded tubes.
Light painting tubes: no. Light painting tubes have no threads anywhere, and no adapter changes that. A saber tube with the thread built into the polycarbonate is the only thing this cap mates with.
This cap is optional. A Flow Cap on its own is the usual setup, but the Twist-On Cap adds brightness and can be run with or without one.
