Dots Combo Light Painting Tube
WRITE REVIEW
The Dots Combo Light Painting Tube uses a dual-sided laser-cut design to create two distinct light painting effects in a single tool.
Required: the RGB Critter Tube Adapter, sold separately, since this tube has no threads on either end. Works with all RGB Critter Flashlights, also sold separately.
Full details and specs Show less
Highlights
- Large dots for bold, high-impact trails
- Graduated dots for evolving textures as the tube moves
- Pushes into the RGB Critter Tube Adapter and locks with two set screws
- No threads on either end. Parts that thread straight into a tube, like the Saber Twist-On Cap, are saber tube only and do not fit this tube at all. A Modular Saber Tube Adapter clamps on to add an AOAM female thread for the accessories that use one
- Ships with a silicone cap on both ends to keep dust and dirt out
How it connects
- Twist the RGB Critter Tube Adapter onto the front of your RGB Critter.
- Push this tube into the adapter's socket.
- Tighten the adapter's two set screws with the hex key that comes with it. The six openings along the top of the adapter are light ports, not screws.
Parts you may need
- RGB Critter Tube Adapter (required). This tube has no threads on either end, so this is what holds it on your Critter. It twists onto the Critter's front, the tube pushes into its socket, and two set screws lock it down. Skip it only if you already own one.
- Modular Saber Tube Connector. Joins two tubes end to end for a longer tool. Two set screws per side, four total, all preinstalled.
- Modular Saber Tube Adapter. Required for any twist-on accessory on this tube. It clamps onto a tube end and adds the AOAM female thread that the Modular End Cap screws into. It does not make the Saber Twist-On Cap fit: that cap only threads into a saber tube with the thread built into the polycarbonate.
Compatible with all RGB Critter Flashlights (sold separately).
Details
Made from impact-resistant polycarbonate, the saber’s dual-layered construction ensures smooth light distribution with sharp, defined highlights. Both ends are bare, with no thread of their own. The tube mounts on the RGB Critter Tube Adapter (sold separately), which twists onto the front of the Critter and locks the tube with two set screws. Add the Modular Saber Tube Adapter to give the far end an AOAM female thread for caps and twist-on accessories, or a second RGB Critter Tube Adapter to run a Critter at both ends and double the brightness.
Each tube ships with a soft silicone cap on both ends.
