Spiral Dots Light Painting Tube

Highlights

• Swirling dotted light textures in motion
• Dual-layer diffusion for smooth light distribution
• Pushes into the RGB Critter Tube Adapter and locks with two set screws
• 36 inch: threaded, and the Saber Twist-On Cap is included. The thread is cut into the polycarbonate at the free end, so the cap goes straight on and adds a reflector for a brighter, fuller tube
• 6 to 30 inch: no threads on either end, so a Saber Twist-On Cap will not fit them. A Modular Saber Tube Adapter clamps on to add an AOAM female thread for the accessories that use one
• Ships with a silicone cap on both ends to keep dust and dirt out

How it connects

1. Twist the RGB Critter Tube Adapter onto the front of your RGB Critter.
2. Push this tube into the adapter's socket.
3. Tighten the adapter's two set screws with the hex key that comes with it. The six openings along the top of the adapter are light ports, not screws.

Parts you may need

• RGB Critter Tube Adapter (required). The mounting end of this tube is bare, so this is what holds it on your Critter. It twists onto the Critter's front, the tube pushes into its socket, and two set screws lock it down. Skip it only if you already own one.
• Modular Saber Tube Connector. Joins two tubes end to end for a longer tool. Two set screws per side, four total, all preinstalled.
• Modular Saber Tube Adapter. Required for a twist-on accessory on a 6 to 30 inch tube, which has no thread of its own. It clamps onto a tube end and adds the AOAM female thread that the Modular End Cap screws into. It does not make the Saber Twist-On Cap fit: that cap threads into the tube itself, so it needs a saber tube or the 36 inch light painting tube.

Compatible with all RGB Critter Flashlights (sold separately).