Honeycomb Saber Accessory

The Honeycomb Saber Accessory uses impact-resistant polycarbonate tubing with a dual-layered design: the inner layer evenly distributes the RGB Critter's light while the laser-cut outer layer reveals sharp points of light.

Highlights

• Dual-layer laser-cut design for an interplay of light and shadow
• Impact-resistant polycarbonate tubing
• Pushes into the RGB Critter Tube Adapter and locks with two set screws
• One end is threaded, so it takes the Saber Twist-On Cap or a Flow Cap
• Ships with a silicone cap on both ends to keep dust and dirt out
• Covered by AOAM's Limited Lifetime Warranty

How it connects

1. Twist the RGB Critter Tube Adapter onto the front of your RGB Critter.
2. Push this tube into the adapter's socket.
3. Tighten the adapter's two set screws with the hex key that comes with it. The six openings along the top of the adapter are light ports, not screws.

Parts you may need

• RGB Critter Tube Adapter (required). The mounting end of the tube has no thread, so this is what holds it on your Critter. It twists onto the Critter's front, the tube pushes into its socket, and two set screws lock it down. Skip it only if you already own one.
• Saber Twist-On Cap. Threads onto the tube's threaded end and hand-tightens, closing off the open end.
• Flow Cap, black or clear. Pushes on and pulls off over the threaded end. Friction fit, no twisting. A soft rounded tip for contact work and flow.

Compatible with all RGB Critter Flashlights (sold separately).